Page 1 of 1
changing skin from 2013kx dyno to 2018 fc dyno
Posted: Wed Dec 13, 2023 3:09 am
by DaDAVO#31
So I did the whole changing the names out in notepad but when it try's to load in game it just comes up as the stock mxsim square bike.
kx450f
fc450v2016
Re: changing skin from 2013kx dyno to 2018 fc dyno
Posted: Wed Dec 13, 2023 5:38 am
by KTM57
Does the game list any error messages related to the bike when you load in? You can open the chat with the "t" key to check.
You didn't give very much info to go off of, but if I had to guess, then you may not have jms renamed or you may have renamed one of the components incorrectly.
Re: changing skin from 2013kx dyno to 2018 fc dyno
Posted: Fri Dec 15, 2023 8:39 am
by DaDAVO#31
ok ill check
Re: changing skin from 2013kx dyno to 2018 fc dyno
Posted: Fri Dec 15, 2023 8:46 am
by DaDAVO#31
KTM57 wrote: ↑Wed Dec 13, 2023 5:38 am
Does the game list any error messages related to the bike when you load in? You can open the chat with the "t" key to check.
You didn't give very much info to go off of, but if I had to guess, then you may not have jms renamed or you may have renamed one of the components incorrectly.
So doesn't say that there's an issue just loads in a stock skin or a low polly skin for my case
Re: changing skin from 2013kx dyno to 2018 fc dyno
Posted: Fri Dec 15, 2023 8:54 am
by DaDAVO#31
the low res pack isn't the issue
heres what i did in the saf.
Re: changing skin from 2013kx dyno to 2018 fc dyno
Posted: Fri Dec 15, 2023 8:56 am
by DaDAVO#31
rip dunno how to post a photo