MX Simulator

Hey guys I have a question. I want to make a model for a CR125 (the vintage pack) have the power of the CR250. any help or suggestions? please post a picture if possible in response too.

Thanks~ Yamaham

I don't exactly understand what you're looking for, so I will assume you want to put a CR 125 model on the CR 250.

name the .jm files cr250_xxxxx.jm

This will give you a 125 model on a 250 2t powerband.

Stormz wrote:I don't exactly understand what you're looking for, so I will assume you want to put a CR 125 model on the CR 250.

name the .jm files cr250_xxxxx.jm

This will give you a 125 model on a 250 2t powerband.

I have a vintage bikes pack but its under the cr125 and I want to change it to the 250 but I will try this and see if it works. thanks for the help Stormz

it did not work. could you post a picture of what to change here's the bike: http://www.mediafire.com/?nlyw2zwn50c
!I do not own the bike! here's the thread: http://forum.mxsimulator.com/viewtopic. ... ico#p61736

The link doesn't work.

If the file is a saf, you would have to open the saf to change that stuff. And I'm not one to open saf's, so I will leave it at that.

Stormz wrote:The link doesn't work.

If the file is a saf, you would have to open the saf to change that stuff. And I'm not one to open saf's, so I will leave it at that.

ok thanks for the help its no big deal I just like the 250s power more

you don't have to open the .saf, You just need notepad++ and need to change the part at the top that says 125 to 250 (ik that was a super crappy explanation, but im not on my computer and i havn't done it in about a year, i would suggest looking it on youtube for the rm125 to 250 conversion)