MX Simulator

So I am wanting to put a pond on one of my custom tracks and I am trying to figure out how to do it. Thanks

So you have to download the shaders test track from JLV
Grab one from there
Add as a statue
Use lower tool in editor mode
And place it to fit correctly on your pond.

I HOPE A HELP YOU!
I HOPE SEE YOUR TRACK IN TM

So what files do I need to transfer from the shader testing?

SWAGERDUDE191 wrote:So what files do I need to transfer from the shader testing?

yeh that explanation was confusing for no reason... all you need to do is find a track with a pond you like (ww ranch, any of my JGMX tracks that have a pond) and put the statue into your track. after its in game then you should actually use the liner paint tool because this will insure your ponds base is completely flat. its relatively easy... some ponds sit at a higher elevation above the ground than other ponds so take note of the fact you may have to lower the ground different depths to make the water level the same. hope this helps and none of the ponds I use in my tracks I have actually made