Page 1 of 1
Erode between different traction settings
Posted: Mon Apr 22, 2019 3:50 am
by D_ROY178
Is there a way to convert erode settings so they replicate across different traction settings, eg some sort of equation. I was now informed that erode formation isn’t consistent across different traction settings, when using same erode settings across all.
Re: Erode between different traction settings
Posted: Tue Apr 23, 2019 2:34 am
by jlv
That'd be hard to do since the traction affects the force which affects the deformation.
Re: Erode between different traction settings
Posted: Wed May 01, 2019 9:11 am
by BydesigndecalsCO
jlv wrote:That'd be hard to do since the traction affects the force which affects the deformation.
