Page 1 of 1
[RELEASE] Mika Metal Barpads
Posted: Thu Jul 31, 2014 1:27 pm
by Gasque363
Last week i released my renthal barpads and i got a lot of positive feedback so i decided to whip these up too! Enjoy and please give credits to me - Jarett Gasque
https://www.mediafire.com/?q69mzy62p82a8n7
Re: [RELEASE] Mika Metal Barpads
Posted: Thu Jul 31, 2014 2:19 pm
by Railin' N Trailin'
Sick! Great job! Keep it up!
Re: [RELEASE] Mika Metal Barpads
Posted: Thu Jul 31, 2014 5:51 pm
by BraapBraap
They look pretty nice.
Re: [RELEASE] Mika Metal Barpads
Posted: Thu Jul 31, 2014 10:47 pm
by dbaum25moto
did you skin these or model them also
Re: [RELEASE] Mika Metal Barpads
Posted: Fri Aug 01, 2014 12:06 am
by Gasque363
No the model is the same as on most all bikes i just skinned the barpads
Re: [RELEASE] Mika Metal Barpads
Posted: Fri Aug 01, 2014 1:28 am
by dirtmonkey63
Nice work again! What's next?
Re: [RELEASE] Mika Metal Barpads
Posted: Fri Aug 01, 2014 2:27 am
by Gasque363
dirtmonkey63 wrote:Nice work again! What's next?
Idk what would you like to see?
Re: [RELEASE] Mika Metal Barpads
Posted: Fri Aug 01, 2014 3:34 am
by dirtmonkey63
Maybe Pro Taper or ODI?
Re: [RELEASE] Mika Metal Barpads
Posted: Fri Aug 01, 2014 7:32 pm
by taylerbelle
some ODI bar pads
Re: [RELEASE] Mika Metal Barpads
Posted: Sat Aug 02, 2014 11:46 pm
by Andy_Hack
You want credits because you put a logo on an existing base?
Re: [RELEASE] Mika Metal Barpads
Posted: Sun Aug 03, 2014 12:29 am
by dbaum25moto
Andy_Hack wrote:You want credits because you put a logo on an existing base?
He made the bar pad, give him credits if you use it
Re: [RELEASE] Mika Metal Barpads
Posted: Sun Aug 03, 2014 12:38 pm
by Andy_Hack
dbaum25moto wrote:He made the bar pad, give him credits if you use it
Your knowledge impresses me every time.
Re: [RELEASE] Mika Metal Barpads
Posted: Sun Aug 03, 2014 7:35 pm
by JGeorge22
Andy_Hack wrote:dbaum25moto wrote:He made the bar pad, give him credits if you use it
Your knowledge impresses me every time.
Re: [RELEASE] Mika Metal Barpads
Posted: Sun Aug 03, 2014 9:35 pm
by ONE2TWO
Great Job! Looks Great