Graphics setup when racing with erode? (JLV?)

[KAWASAKIZ]

Hello guys
I'm an old dog (been playing since 2013) and recently i got back into mx sim racing (i'm stuck at home for 3 months because of a injury)
My pc setup is:
i5 4460
8gb ddr3
Rx 470 4gb
Ssd 120gb and 320hdd

Mx simulator in on my hdd. I have no problem playing most of tracks with good graphics (1080p res).
Yesterday i raced the dog national with erode:

I had to put 1680x1050 res (instead of 1920x1080) because it was lagging a lot!

Also i dont know if it depends on how were my graphic settings, but i couldn't see the ruts that were created bu erode during the race and i crashed a lot because of not seeing new bumps or ruts.

I'll attach my graphic settings.

Any trip and tricks? Maybe from amd radeon settings i can do something to get better performances?

I'm just asking 100-111-125 fps and to see the ruts, i don't care if the texture is detailed or not.

Thank you in advance

[KAWASAKIZ]

[jlv]

Looks like you already have reshade delay set pretty high. You might get a little extra by lowering "ground texture levels".