Cutout Help
-
- Posts: 899
- Joined: Fri May 12, 2017 2:23 am
- Location: Alaska
- Contact:
Cutout Help
So I wanted to design some kawi graphics, so I duplicated the cutout layer into a new document, so its just the one layer, but its not that group with the paper clip next to it? How do I make it into that group so that my shapes stay inside the lines of the cutout? I just spent 45 minutes on chat support with adobe and they didn't even begin to help so now I am here. I had a picture of a Honda cutout with it, but imgur wont let me upload it so now I have to hope you guys know what I am talking about. thanks guys.
jlv wrote:WTF I love Trump now! Make America great again!
-
- Posts: 899
- Joined: Fri May 12, 2017 2:23 am
- Location: Alaska
- Contact:
Re: Cutout Help
But the group is for a honda cutout and this is a Kawasaki cutout.nickuzick wrote:You could just copy the group. That would be your easiest solution
jlv wrote:WTF I love Trump now! Make America great again!
Re: Cutout Help
Oh, my bad. Misread that. Rasterize the cutout layer and go Layer/Layer mask/From transparency
-
- Posts: 899
- Joined: Fri May 12, 2017 2:23 am
- Location: Alaska
- Contact:
Re: Cutout Help
thanks man. sick graphics btwAHeckman2 wrote:I show how to in the beginning of this livestream-
jlv wrote:WTF I love Trump now! Make America great again!
-
- Posts: 2920
- Joined: Thu Aug 06, 2015 12:11 am
- Team: Heckman Productions
- Location: Michigan, USA
- Contact:
Re: Cutout Help
Thanksdawsonsleeper wrote:thanks man. sick graphics btwAHeckman2 wrote:I show how to in the beginning of this livestream-