MX Simulator

So I wanted to design some kawi graphics, so I duplicated the cutout layer into a new document, so its just the one layer, but its not that group with the paper clip next to it? How do I make it into that group so that my shapes stay inside the lines of the cutout? I just spent 45 minutes on chat support with adobe and they didn't even begin to help so now I am here. I had a picture of a Honda cutout with it, but imgur wont let me upload it so now I have to hope you guys know what I am talking about. thanks guys.

You could just copy the group. That would be your easiest solution

nickuzick wrote:You could just copy the group. That would be your easiest solution

But the group is for a honda cutout and this is a Kawasaki cutout.

Oh, my bad. Misread that. Rasterize the cutout layer and go Layer/Layer mask/From transparency

I show how to in the beginning of this livestream-

AHeckman2 wrote:I show how to in the beginning of this livestream-

thanks man. sick graphics btw

dawsonsleeper wrote:

AHeckman2 wrote:I show how to in the beginning of this livestream-

thanks man. sick graphics btw

Thanks