Post about creating and skinning models here
4 posts • Page 1 of 1
So i have a saf'd bike model that has a psd that has been provided and i've just edited the psd by like putting a black square on the rear fender and exported as a png. Then ive tried naming it with the same name as the saf file with what i think the dyno name is (250sxf) infront of that with a dash, for the most recent ktm, but i feel im naming it wrong or something is anyone ale to help? Thanks
Best in the world!......
At stupidly crashing
you need jm's for the bike if you dont already, and for the ktm 250 the naming is - "250sxfv2016" Also if the psd is just a cutout, you need a full template
Smidly wrote:With all that's going on right now heres some appreciation for our Black
Been a minute since I've done any skinning, so don't take my word for it. But I believe if you have the correct template and not just the cutout, just name the png's the same as the jm's in the saf. To check the names, open the saf with notepad++ and the names of the jm's should be at the top!
Who is online
Users browsing this forum: No registered users and 20 guests