2010-02-06 snapshot
2010-02-06 snapshot
Changes:
- Editor's radial mode is now a half circle rather than a full circle.
- Editor now draws the brush as two circles. Inner circle is 100% and outer circle is 0%.
- Height and slope are now printed when the gradient editor is up.
Windows users: http://mxsimulator.com/snapshots/mx-2010-02-06.exe
Linux users: http://mxsimulator.com/snapshots/mxbin-2010-02-06
Replace mx.exe or mxbin with one of the above files. I'd keep a backup of the originals since these aren't well tested.
- Editor's radial mode is now a half circle rather than a full circle.
- Editor now draws the brush as two circles. Inner circle is 100% and outer circle is 0%.
- Height and slope are now printed when the gradient editor is up.
Windows users: http://mxsimulator.com/snapshots/mx-2010-02-06.exe
Linux users: http://mxsimulator.com/snapshots/mxbin-2010-02-06
Replace mx.exe or mxbin with one of the above files. I'd keep a backup of the originals since these aren't well tested.
Josh Vanderhoof
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Re: 2010-02-06 snapshot
going to test this right now
TEAM VITAMIN WATER YAMAHA
MX SIMULATOR - IN MOTION
http://www.youtube.com/watch?v=I5NKNqRy-G0&hd=1 <--- WATCH IT!
MX SIMULATOR - IN MOTION
http://www.youtube.com/watch?v=I5NKNqRy-G0&hd=1 <--- WATCH IT!
Re: 2010-02-06 snapshot
I know that you had said that you were going to make the next snapshot set to high priority. Is this one? Because i hate having to set it to high everytime i play. I was telling bill earlier today, my fps was going from ~10 fps to ~100 fps. I honestly saw it at 15, then it flew up to 105. and it kept changing. But once i set it to high priority, it says from 30 to 60/70.
Re: 2010-02-06 snapshot
Since the previous snapshot it has been using SetForegroundWindow to raise the priority a bit. If you want more you can try changing the shortcut target to: start /b /abovenormal "c:\Program Files\MX Simulator\mx.exe"
If that isn't enough use high instead of abovenormal.
An even better solution would be to figure out which startup program is slowing you down and disable it.
If that isn't enough use high instead of abovenormal.
An even better solution would be to figure out which startup program is slowing you down and disable it.
Josh Vanderhoof
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Re: 2010-02-06 snapshot
Thanks for that
And when i go to control panel, and click change startup programs, nothing opens. It just shows the loading mouse image for about 1 second then it does nothing.
And when i go to control panel, and click change startup programs, nothing opens. It just shows the loading mouse image for about 1 second then it does nothing.
Re: 2010-02-06 snapshot
Josh Vanderhoof
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Sole Proprietor
jlv@mxsimulator.com
If you email, put "MX Simulator" in the subject to make sure it gets through my spam filter.
Re: 2010-02-06 snapshot
I usually use msconfig to change the startup programs. Open Run and type msconfig then Enter, then go to the Startup tab.
TeamHavocRacing wrote:If I had a nickel for every time someone asked for this, I would have a whole shitload of nickels.
Re: 2010-02-06 snapshot
Wow, I'm not an editor type guy, but this is gonna make ppl's lives soo much better. Such a simple but amazing snapshot!
Re: 2010-02-06 snapshot
I noticed the other changes but I never did see this one. Somewhere I'm not looking?jlv wrote:Changes:
- Height and slope are now printed when the gradient editor is up.
Re: 2010-02-06 snapshot
When you're in gradient edit, look over near were all of the tools are, at the bottom you'll see the measurements of the point you click on.
Re: 2010-02-06 snapshot
can someone help me with the snaps shots =/ every time i try to run one it says cannot find game data
DJ wrote: That top creators list is rooted. Don't even take notice of it. I'm not even on the darn thing.
Re: 2010-02-06 snapshot
The exe has to be in the Mx Simulator install folder (Probably C:\Program Files\Mx Simulator).
TeamHavocRacing wrote:If I had a nickel for every time someone asked for this, I would have a whole shitload of nickels.
Re: 2010-02-06 snapshot
Yeah,it has to be in there and it has to be renamed to just "mx.exe".But you should have the the original mx.exe,just rename that to mx-orig.exe
Re: 2010-02-06 snapshot
WTB New Snapshot With some funny updates! Its been a while...
Re: 2010-02-06 snapshot
What sort of funny updates? Like a guy with long arms?