MX Simulator

Recently the rear brake has nearly stopped working for me. The rear brake does nothing on the ground but in mid air it will slightly lower the nose of the bike, so that means it is working at least a little bit. my settings havent changed in the past year and its not my controller because i have tried switching the buttons for the brake. i just uninstalled mx simulator and re installed it but it still does the same thing. Also i have restarted my computer multiple times and it has not changed. my rear braking torque is still 500 so thats not the problem either. any help?

I thought this was normal? I can't stop the bike with the rear brake its pretty much useless. Only good for keeping the front down on jumps.

Do you have the rear brake set to anti-lock?

I do, yes

jlv wrote:Do you have the rear brake set to anti-lock?

Yes i do

Boblob801 wrote:I thought this was normal? I can't stop the bike with the rear brake its pretty much useless. Only good for keeping the front down on jumps.

and yes thats what it usually is good for but now i will go flying off of berms because i cant stop enough in time like i used to.

I meant you should turn off anti-lock.

hey JLV, im using anti block and both brakes on LT .. but is there something I can do to be able to hold the brake (at 50% for exemple) and still be able to gas? .. cuz right now if I brake = cannot gas at all .. i'd like to be able to brake at 50% and gas it on the berm just like IRL !

If your controller puts the tiggers on the same axis they'll lock each other out.

I'm using 360 controller and I remember someone talkin about it (that ita possible to unlock the axis)

XBCD driver instead of the microsoft driver.

SMR 510RR wrote:XBCD driver instead of the microsoft driver.

Tried it

Did you setup the drivers or just install them? http://forum.mxsimulator.com/viewtopic. ... 58#p550358