MX Simulator

Hoping this is the correct place for advice...

I was wondering how/if it's possible to run high detail bike and gear, while running low detail environment. My PC (SP4 i7 16gb) can handle full gate on high fps around 45fps , while maybe 14 fps full gate with high detail settings. I'm sure it can handle full detail on the bike and gear with high fps-level environment while staying above 35 fps full gate.

I have tried starting at high detail and going into advanced settings and turning sliders down but i'm not really sure what i'm doing. I assume this is the way to go but any advice would be greatly appreciated.

I can't imagine I'm the only one to think of this, and if it has been answered before, link it please!

Thanks!

Go to > GRAPHICS/SOUND SETUP > ADVANCED GRAPHIC SETUP


• GROUND GEOMETRIC DETAIL CHANGE IT TO 100

• GROUND TEXTURE LEVEL CHANGE IT TO 10

• GROUND TEXTURE RESOLUTION CHANGE IT TO 32x32

• MODEL GEOMETRIC DETAIL CHANGE IT TO 100

• MODEL TEXTURE DETAIL CHANGE IT TO 10

Hope this help you.

I set the ground wrong
Now its good
Go to > GRAPHICS/SOUND SETUP > ADVANCED GRAPHIC SETUP


• GROUND GEOMETRIC DETAIL CHANGE IT TO 0

• GROUND TEXTURE LEVEL CHANGE IT TO 0

• GROUND TEXTURE RESOLUTION CHANGE IT TO 32x32

• MODEL GEOMETRIC DETAIL CHANGE IT TO 100

• MODEL TEXTURE DETAIL CHANGE IT TO 10

Hope this help you.

For whatever reason I didn't read "model" as the bike and rider lol thanks for the help!!!

You don't want ground geo detail at 0 because then the terrain won't load until you're practically on top of it. Set it at like 30 and you should be fine