2011 Suzuki Rmz250

[attacker5]

Ok i listened, i took a look at the yzfs and i see what you mean, i also got the plastics like you guys wanted, i know its huge, but i want to get very good quality in it, i will make it smaller later if i find i need more detail somewhere else. I have also finished teh front fender but i still need to map it.

[eXL'Mo0seY]

Your still not listening. Put all the part's together like they would be. Make the plastics all one piece and flow. If it's hard for skinners, they wont make them simple. I know i don't like spending more time on something because it's got a shit UvMap.

Listen To People's Critism

[attacker5]

Your still not listening. Put all the part's together like they would be. Make the plastics all one piece and flow. If it's hard for skinners, they wont make them simple. I know i don't like spending more time on something because it's got a shit UvMap.

Listen To People's Critism

How about you read my post again, i said i did what i could, that plastics are unwrapped so damn close to the yzf's you guys are being full of crap. Especially you.

[eXL'Mo0seY]

Im only trying to help, but if you dont want any help, dont show it.

[attacker5]

Im only trying to help, but if you dont want any help, dont show it.

Your not trying to help.

[attacker5]

Away from that now, do you think it will be worth it to have it smaller and have the rear fender lined up with the back or is it worth it to have the higher resolution?

[eXL'Mo0seY]

FENDER LINED UP, move that stuff from were the back fender should be to where the back fender is now and move the back fender into position..

[attacker5]

Ok, i even think this is better now...

[attacker5]

My internet is causing double posts!

[eXL'Mo0seY]

Better, now you just gotta give some of those small parts some space to be skinned then your set

[Jester#132]

yea it looks better this way attacker, can't add much to what eXL said.

[attacker5]

Res wise they are the same as i got them, i know the are packed, but that's cause im saving space, its just gonna mean some careful work.

[Jester#132]

its just gonna mean some careful work.

yea I guess you only have to do metals etc. one time, except if people wanna make their own skins, but you could release a public template when it's done..

[mace-x]

i´d recomend not to put the pieces so close, eg the shrouds to the seat, it´s a pain to skin

[mxsstarters]

ill be completly honest with you. i dont like them. the back plates are to big and the front forks have to much slant on them. other than that it is pretty good.