Tables in SX

[jackson29382938]

Hi all,
I am pretty good with everything except for tables in sx.
Only at super high speeds am I able to get over the next jump.
I currently just lean forward then backwards off of a table but sometimes the front and mostly the back tire keep hitting the next jump.

Would yall have any suggestions to clear a tabletop and the following jump(s)?
Thanks

[baker]

Hi all,
I am pretty good with everything except for tables in sx.
Only at super high speeds am I able to get over the next jump.
I currently just lean forward then backwards off of a table but sometimes the front and mostly the back tire keep hitting the next jump.

Would yall have any suggestions to clear a tabletop and the following jump(s)?
Thanks

Leaning front then back is part of how I get over them. I also will upshift going off the table. Make sure you don’t land on the table too far to get a good drive and hop off the table. Another thing that will be helpful is getting better at clipping the landing off the table. I still clip it every now and then but I don’t crash since I can soak it up fine

[Jrife548]

Try to land both wheels first, and lean forward slightly, then do an mx vs atv preload off of it right at the end. upshift as your preloading.